View previous topic :: View next topic |
Author |
Message |
markdesmarais2015
Joined: 05 Dec 2015 Posts: 10
|
Posted: Wed Dec 09, 2015 6:01 pm Post subject: Nevo C2 pixelated language screen |
|
|
New Nevo C2 user... did my initial upgrade on EZ-RC, no problem. Added some devices, disconnect, reconnect several times. Got RemoteMaster working (thanks guys!) did a download and saved the file, back and forth a few more times with EZ-RC adding more devices, more downloads... everything seemed to be going fine.
Left the remote plugged into the PC during the day- ran the batteries flat. Changed them for another set, and I get a pixelated language screen, and no ability to connect over USB. Can't get EZ-RC to connect either. Put the batteries in and out about a hundred times- same result.
Holding power and OK gets me into Upgrade mode... now EZ-RC does an update, with the % success dependent on how close to the root USB port I am. Plugged right into the MB connector, I see the upgrade run for about 14 seconds, then the remote reboots, and I get a blank screen, and the process ceases (please connect, may take up to 5 sec, never does).
I found a few references to this on the AVS post, but it seems like most people just changed the batteries and it started working.... anyone got more suggestions? I'm about to do a return. Soooo frustrating!
thanks
Markd |
|
Back to top |
|
|
markdesmarais2015
Joined: 05 Dec 2015 Posts: 10
|
Posted: Wed Dec 09, 2015 7:38 pm Post subject: |
|
|
OK, read the reset page more carefully... doing a power,1,3 battery combo did not APPEAR to change anything on the remote (still came up with a pixelated language screen) BUT now EZ-RC was able to update the remote! Looks like everything is working now! |
|
Back to top |
|
|
mdavej Expert
Joined: 08 Oct 2003 Posts: 4501
|
Posted: Fri Dec 11, 2015 2:31 pm Post subject: |
|
|
Glad you were able to recover. I have one remote with strange pixellation on some screens as well and would like to force another firmware update. Exactly how did you get into upgrade mode? Did you have to remove the batteries first? |
|
Back to top |
|
|
vickyg2003 Site Admin
Joined: 20 Mar 2004 Posts: 7073 Location: Florida |
Posted: Fri Dec 11, 2015 10:14 pm Post subject: |
|
|
What is this power 1, 3 battery thing? Is that supposed to be some kind of reset for this new remote? If so does that belong in the master reset instructions in the wiki? |
|
Back to top |
|
|
mdavej Expert
Joined: 08 Oct 2003 Posts: 4501
|
Posted: Fri Dec 11, 2015 10:44 pm Post subject: |
|
|
Good idea. I just added it. Still not sure how to force upgrade mode, only get out of it. |
|
Back to top |
|
|
vickyg2003 Site Admin
Joined: 20 Mar 2004 Posts: 7073 Location: Florida |
Posted: Fri Dec 11, 2015 10:53 pm Post subject: |
|
|
Thanks |
|
Back to top |
|
|
|