Zaaptv Model 509 remote IR code

adfree · Post by **adfree** » Sun Feb 15, 2015 8:35 am

the 2 sources of video was the problem now all works from iPhone and iPad finally its contralable , thanks a lot for your help

alanrichey · Post by **alanrichey** » Sun Feb 15, 2015 10:25 am

Good. But what do you mean by 'everything' ? I probably need to add that to the list of questions.

adfree · Post by **adfree** » Sun Feb 15, 2015 1:51 pm

alanrichey wrote:Good. But what do you mean by 'everything' ? I probably need to add that to the list of questions.

everything means all activated buttons are working , color buttons refresh , change channel , power all

you should add a question asking if the ZAAPTV is the only source of video connected to it

and they should also start by resting the 350 to start fresh

and i had better result with firefox

i find it work perfectly under cable box - custom then load the C2010_PL.bin and TEST

the white light thing is not really valid question

just a question apart from this subject , is it possible to change the firmware of the sling player and have more than one viewer to watch , because sling limited to one at the time

thanks

alanrichey · Post by **alanrichey** » Sun Feb 15, 2015 2:25 pm

I actually meant what did you reset. Now I know you meant the Slingbox I will add it to the instructions as one of the questions.

If you read the instructions carefully you will see it only mentions the white flash in relation to the older Slingboxes, where it is very definitely a valid question.

And no, you are stuck with one viewer at a time.