JP1 Remotes

Carl · Posted: Fri Aug 01, 2014 9:01 am Post subject: JP2 remotes

Hi,

I am programming a JP2 remote URC-1056 with remote master last beta version.I can add new devices codes but I cannot find the way to set any keymoves.. Is this normal since it's a JP2 remote?

mathdon · Posted: Fri Aug 01, 2014 1:33 pm Post subject:

Hi Carl. I presume this is the Atlas 1056B03. This does not support keymoves in its standard form. However, I wrote this extender that adds keymove and device-specific macro capability. As the file section says, this is the first extender for a JP2 remote and so far is the only one. It does say it is experimental, so use at your own risk, but by now I think it can be taken as tried and tested.

It is a simple extender and not like any other in its installation, so be sure to follow the instructions given in the installation package. The current official release of RMIR is v2.02a and this (and any later development version) supports this extender, so you don't need the version mentioned in the description.

If I am wrong and this is not your remote, please do NOT try this extender as it is very specific to that remote.
_________________
Graham

Carl · Posted: Mon Aug 04, 2014 11:26 am Post subject:

Hi, I have installed the extender, but I cannot find where to add keymoves in remote master.

mathdon · Posted: Mon Aug 04, 2014 12:27 pm Post subject:

Once the extender is installed, if you download the remote into RMIR you should see the Keymoves tab. Note that the remote with the extender has a different signature (2010A9 rather than the original 201009), so RMIR should be picking up a different RDF. If you can't sort it out, download your remote, save it as a .rmir file and post it in the Diagnostics section for me to look at.
_________________
Graham

Carl · Posted: Mon Aug 04, 2014 12:44 pm Post subject:

I see it now! Thank you very much for your help.
It's nice to have an extender for this remote since the old B01 is getting hard to find.