| View previous topic :: View next topic |
| Author |
Message |
PeteHarland
Joined: 23 Dec 2007
Posts: 18
Location: Bacchus Marsh, Victoria, Australia
|
 Posted: Mon Dec 09, 2013 6:00 am Post subject: Latest IR Widget design needed |
 |
|
| Does anyone have details of the latest IR Widget? The one listed on the forum seem to be a prototype and I hear that Tommy Tyler’s unit is no longer available. |
|
| Back to top |
|
 |
Barf
Expert
Joined: 24 Oct 2008
Posts: 1415
Location: Munich, Germany
|
| Posted: Mon Dec 09, 2013 2:48 pm Post subject: |
|
|
| Unfortunately, Tommy never published exactly what went in -- in contrast to Kevin, who published firmware and board designs. However, the one I have is essentially the usb_simple design from Kevin's site: A small board marked T. Tyler, eqipped with a USB connector, an FT232RL chip for USB communication, the 12F629 PIC controller, and a wire to an QSE157 or -159. |
|
| Back to top |
|
|
PeteHarland
Joined: 23 Dec 2007
Posts: 18
Location: Bacchus Marsh, Victoria, Australia
|
| Posted: Tue Dec 10, 2013 5:17 am Post subject: Latest IR Widget design needed |
|
|
| I am going to build the comprehensive IR widget. Can anyone tell me the value of inductor L1? Also can anyone tell me what type of sensor is used for IRDEMOD1? I presume that the circuit uses IRDEMOD 1 or 2 and IRDET1, IRDET2 or IR LED D3. |
|
| Back to top |
|
|
Barf
Expert
Joined: 24 Oct 2008
Posts: 1415
Location: Munich, Germany
|
| Posted: Tue Dec 10, 2013 2:07 pm Post subject: |
|
|
Kevin is really the right person for this, but I will make a try.
| Quote: | | Can anyone tell me the value of inductor L1? |
If it was critical, there would have been a value...  Kevin is extremely careful to filter the supply voltage, Tommy is not.
| Quote: | | Also can anyone tell me what type of sensor is used for IRDEMOD1? |
Basically anything TSOPxxyy, yy denotes the modulation frequency in kHz. Note that there are several different pinouts available, be sure that you read the data sheet before you plug in the soldering iron.
| Quote: | | I presume that the circuit uses IRDEMOD 1 or 2 and IRDET1, IRDET2 or IR LED D3. |
Need an explanation to "Choose one or none"? Do not choose D3.
You may also consider a more modern alternative to QSE15x, which has very short range, and is not 3.3Volt compatible. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
File Section
Wiki
