JP1 Remotes Forum Index JP1 Remotes


FAQFAQ SearchSearch 7 days of topics7 Days MemberlistMemberlist UsergroupsUsergroups RegisterRegister
ProfileProfile Log in to check your private messagesLog in to check your private messages Log inLog in

My 9910 is now hard work
Goto page Previous  1, 2, 3, 4
 
Post new topic   Reply to topic    JP1 Remotes Forum Index -> JP1 - General Forum
View previous topic :: View next topic  
Author Message
bobcat



Joined: 23 Jan 2013
Posts: 1
Location: United States

PostPosted: Wed Jan 23, 2013 3:36 pm    Post subject: URC 8910 question on modem that came off Reply with quote

The Robman wrote:
The modem is a white plastic coil with copper wire wrapped around it.

The RF puck is a mini-PCB.

A rattle would be caused by a loose modem. The coil is just held in place with glue, that typically becomes brittle with age and breaks off.


I know this is old but I hope someone can answer. My modem came loose on the URC 8910 remote and fell off. I am trying to figure out where the copper wire was attached if at all to the circuit. Thanks!
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic       JP1 Remotes Forum Index -> JP1 - General Forum All times are GMT - 5 Hours
Goto page Previous  1, 2, 3, 4
Page 4 of 4

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


 

Powered by phpBB © 2001, 2005 phpBB Group
Get Smart! the band's official homepage Rockabilly Central