JP1 Remotes

I have a Kameleon URC 9960 I also have another One for all. I want to set up the Kameleon to opporate one star choice reciever. I tried uploading the different codes with the files listed for addresses 1,2 and 3 but only the 0000 one works. I am changing the address with my star choice remote and ...

1. Device: Pioneer DVR-450H-S
2. Type of device: DVD player (HDD/DVD Recorder)
3. Year: 2007
4. JP1/UEI Remote model: URC-9911
5. Do you have a JP1 cable? Yes
6. Still have original remote? Yes
7. Checked the file section? Yes
8. Checked Pronto file section (at R/C)? Yes
9. Partially working ...

Hey all thought I would let you know I unplugged the DVD player overnight and in the morning when I plugged it in the clock was correct and the DVD recorder was still at DR-2, so there must be an internal battery. perhaps I would have to open up the DVD Recorder and take out the battery for a few ...

Hey Stalt,
What code or upgrade were you using to control the recorder with the 9910? Were you using the standard DVD/0503 code, or an upgrade that used NEC1 with device code 69 (and no sub-device)? If so, there might be hope. I asked Edmund if he knew anything about this and he replied that he ...

the instructions to change the address of the remote are to hold the setup button and then push button #1,2 ,3 depending on what address you want the remote to be(and match the DVd player).

I would need to change the remote to #2 as I changed the DVd to #2...

Well if you are offering help I will gladly accept.

I do have the JP1 cable and have soldered a six pin into the new remote (URC9966 - same as 9960)

I loaded the device file from the device section but did not see an option to change the remote address which is what I would need to do.

if someone ...

Hey all,

I just cost myself $70 so I will explain it here so hopefully you wont do anything so stupid!

I have a Toshiba DVD recorder RD-XS32 bought off Ebay with no remote.

I had a URC-9911 programed to do everything the factory remote would do and it worked fine. I used it to do everything I ...

Soldered on a 6 pin today and was able to program! Comes up as the 9960 4mg epprom!

Hey everyone,


Recently bought this remote...It has pads and it is indicated as JP1 on the board...Thre seems to be no RDF, but I am thinking the 9960 should work..Any thoughts?

Just want to check before taking it apart and soldering on a 6pin...

link to the remote is attached.

http://www.avs ...

Hi I just got today a new All For One Kameleon 9966 with RF Extender.

I had the 9911B00 previously and used JP1 to configure, load device, keymove etc.

Please note these were both bought here in Canada so the numbers might be different.

The new one has pads so I know I am going to have to get the ...