JP1 Remotes

there was a short between pins 1-4 (ground) and pin 6

ther was some resistance between pins 3 and 5.
i did a touch -up on eeprom on pads 5-8. noe it's workink ok.

thank you guys for all your help

thank you guys. i do have a multimeter so i will check a short in between pins 3 and 5.

last night i did check voltege going into eeprom (when running on batterie) i could not find anything abowe .7V) it that normal.

100ohm resistor is ok.

thank you

johnsfine wrote:How was it modified for JP1.

It sounds like something is shorted to the reset signal.

also, i have made my own parallel cable (2 x 1k resistors , 1 x 1n4148 diode, pins 1+2 are bridged)

it's modified with mouser Part# http://www.mouser.com/index.cfm?handler=displayproduct&lstdispproductid=528842&e_categoryid=244&e_pcodeid=57989

it works fine as lons as remote is connected to pc (reset 981 works fine- -four blinks, comunnication with ir.exe is ghood, upload/download works fine too ...

i have a problem with my 6131nw. it will only work/ function when connected to pc using paraller port. when it's running on batteries i get no response from remote. comunnication with ir.exe is ok. i can download - upload with no problems.
i tried replacing new batteries with old but still no ...