JP1 Remotes

Thank you. I will try this and let you know how I make out.

Sorry for the lack of details.

With remote directly everything is good.

I put blocked the IR on the remote and made sure it would not control the devices directly. I used the RF unit holding it with my hand in front of the Sat. Everything worked fine (my wife ran the remote). Then I held the RF ...

Hi,

I have done most of my programming with success. Now I am trying to use the RF repeater that came with this remote. It seems that the onkyo receiver codes that I programmed with JP1 do not get transmitted correctly through the RF interface. Does anyone know of a remote (with JP1) that has RF ...

All of you are right. I moved the discrete to a different key and it worked then I tried the setup setup 1 and that worked also. I think I am all set for now. Thank you all very much. You are allowing me to make a $40 remote do what a $300 remote does. I love it.

Hi,
I have a URC-9910B00. I programmed it with this file.

https://www.hifi-remote.com/forums/dload.php?action=file&file_id=4255

It said that it supported discrete on/off but I can not figure out how. It controls my TV sharp 42inch lcd but I can not figure out how to get the discrete on/off and the ...

That was it. Thanks for the help!

OK I think I found the problem. On the button page in KM the channel up and down was set to page up and page down. If I set it up to Channel up and Channel Down it fixes these buttons. I am sure I can fix the other buttons now.

I do have one other question. When I select my new device (sat) the ...

Yes I did set the CD and AUX button to the approiate device on the general tab in IR. KM did not indicate that a protocol upgrade was needed.

I am using IR 6.15 and RM 1.15 and KM 8.35.

I down loaded the coolsat_4000_pro.txt loaded into KM piced my device URC-7800. I copied the upgrade code put in into IR on the devices tab and tested. My first observation is that the channel up down does not work.

IR says it is this.

Cable: 1554 ...

Thank you. That did it.

I did the master reset and I still get the same error. Any other ideas?

I have just connected my URC-9910B00 to ir.exe (6.15) and I am getting a error "no definition file exit..." when I try to read the remote.

I am not sure what to do next. Help!