JP1 Remotes

hi varaonaid, would you consider selling one of the 15-2117?

If your most recent post is correct, the data you posted earlier is really for addresses 1 and 3, not 1 and 2, so therefore the upgrade that I posted is really for address 3 rather than 2.
That's correct. I had originally posted the info for address "1" and address "3", but had mistakenly ...

There are three addresses that can be selected from the initial setup on the recorder. To select the appropriate address on the DVR520 remote, you hold the return button and press "1", "2", or "3". Here's the learned code data I picked up for these three addresses.

Key pressed "1"
Address "1 ...

Excellent! I just uploaded your upgrade into my 2117 and all the keys appear to be working properly! Thanks for all your effort!

Just so you and everyone else planning to use this upgrade know, the remote address setting to set on the "initial setup" of the DVR520 is "3". I listed address 1 and ...

Sorry. Below is the Learned Signal info from IR after learning two different keys for two different addresses on DVR520 remote.

Key pressed "1"
Address 1:
#, Protocol, Device, Sub-Device, OBC, Hex Cmd, EFC, Misc
1, Pioneer, 171, , 44, CB, 084,
2, Pioneer, 175, , 161, 7A, 225,
Address 3:
#, Protocol ...

Thanks for the suggestion.

I learned the same command for two different addresses from my DVR520 and the differences were only in command #1 for the OBC, Hex Cmd, and EFC. I changed the the OBC in KM and copied over the new device upgrade code into IR, but the remote still appears to be sending the ...

I tried changing the remote address on my HDVR2 DirecTivo unit to all 9 different address codes (1-9) and my Pioneer DVD recorder remote (DVR520) still causes certain commands to be executed on the HDVR2. When I change the remote address on the DVR520 however, the DVR520 remote no longer causes the ...