JP1 Remotes

Wow, that was quick! good to see you are still at it.

Yes, although my post was a bit premature as I forgot about the IR.exe application and flash process, I did have my files backed on disk and flash was successful.

At the very least i hope these posts help someone else.

-ds

Hey, so its been quite a while since I have done any JP1 programming.

I have a urc-8910 which i programmed almost 2 years ago, well the batteries finally kicked out and when i replaced them nothing worked.

I did the original flash with remote master (v 1.6...something) and have not touched it ...

i jist thought i would let everyone know there are some bad codes in the this upgrade.

the fav key is actually mute, both 248

there are a few more i will post back with the full list and hopefully the correct codes (i need to borrow a remote)

big thanks!

Sorry to hear about jon armstrong... I see his name all over the place for programming remotes for keyboards, and this will truly be a loss for the community.

Just to clear things up , I am NOT dealing with a debounce issue, that is only for universal remotes programmed to use the MCE IR Receiver ...

thanks rob, definately confused

figured out the rdf problem...

how about the "bad checksum" issue?

I have been reading and searching (here) alot since i ordered the remote

Here is where I am at:


Hardware:

Received a URC 8910 with JP1 cable and have it hooked up to my PC via parallel port


Software and steps taken so far:


1. IR600.zip

a. Installed and backed up the factory settings ...