JP1 Remotes

Thank you, I couldn't have done it without the help of this forum.

Everything works except ENTER (15). It should be 92, same as OK/select. The button on the remote map which is code 15 is not labeled and does nothing.

I'm going to post an updated rdmu. It would be nice if the mouse over the button showed the action e.g., instead of 'red' it said 'CC". In my copy of the working bin I have the following:
skip+ 33
Skip- 20
Custom 14 (labeled IPTV on remote) 76
TV/VCR (labeled & does TV/Radio) 70
ENTER (same as ...

Using the physical remote when watching satellite channels, CH+/- change channels and the double_arrow+/- (skip+/-) have no function. When watching recordings, both CH+/- and skip+/- do the same thing, so I may have been in error to say skip- was also 31. It must be something else so that it ...

33 and 31 work OK as PAGE +/-, but I prefer to put volume +/- (21 and 28) on those buttons. This volume control moves the volume two steps, while left/right_arrow moves the volume one step. 33 and 31 work only while in the DVD mode and are perhaps better relegated to the original skip +/- accessed ...

My error, Custom 10 is Favorite, as in favorite group of channels. I would put skip+ as 33 and skip- as 31, otherwise it tests OK.

I stumbled around until I found something that worked and that was editing the bin from the GeosatPro HDVR1200.

The double up arrow is 33 and is used to move up the recorded program list while playing another recording. I put in on button 'skip+' in my copy of the bin. Likewise 31 is the double ...

There are two remaining buttons to be discovered in the DVR functions. I have only used the STB as a satellite receiver so I'm not familiar with the recording functions. However, in testing buttons I did trigger several recordings and I now know that the double_up_arrow moves up in the recording ...

Shouldn't the bin file be posted in the Slingbox Binary File section?

The Robman wrote:Ok, I have reverse engineered the RM file from your bin file and have replaced the file myself.

Thanks, because all I did was edit the bin file. I never figured out how to go from a RMDU to bin.

The down_arrow is OBC 90, hex 5A. Now it functions to change channel and to navigate when in the menu mode.
Unresolved are hex 1B and hex 43. There are not enough buttons on the default remote to test these, but if the pattern follows, hex 43 will be 'USB' and hex 1B will be 'ACCESS', with 'ZOOM ...

The audio, green button is hex 20, OBC 32. OK/select is hex 5C, OBC 92. Setting down_arrow to hex 1E, OBC 30 has it function as down channel, but not as down arrow when navigating menus. I'll post a corrected bin, but it uses the default remote which does not have all the functionality of the ...

Audio, the green button is OBC 41, hex 29. The map says it is hex 17, but that brings up 'History'.

I will try to upload the remote map after I write this. It is becoming clear that the problem is errors in the map. There are five codes that are used twice: 0D, 0E, 17, 1D, and 43. The code 0D is mapped to both mute and OK/select. 0D was assigned to mute during manufacturing and we don't yet know ...

OK, I have the remote code map, courtesy of GeosatPro, but I'm confused now as the button codes are not all decimal values. The 'OK' button is shown as 0D and the mute is 0d. Signal is 0C, but in the revised bin above the code 13 served up the signal. I'm not sure where to go from here!