JP1 Remotes

After the bad learns, factory reset the remote:

1. press and hold the TV POWER button and the Back button.
The Ring should blink yellow twice

2. Press Options, REPLAY and HOME consecutively, the ring should blink RED 4 times


To program the Roku tv:

1. Hold down the STB POWER and HOME buttons ...

I am aware this is a rather basic remote, however I have ran into a little issue. A friend lost their old URC7935, and got a replacement. However, the new one will not actually work on the Roku TV fully like the previous one.
I can't seem to get it to work without learning from the OEM remote ...

mathdon wrote:I have now released RMIR v3.0.3 which I believe fixes your problem. Please test it and report back. If you still have problems with it then I will fix them in the next build.

Sorry it took so long, had a busy day. Everything seems to be working properly now, thank you!

I am more then willing to upload both files if needed, I just need to know where to do this.
Please do upload them. To do so, click on File Section in the menu that is at the top of every forum page, select Diagnosis Area and press the Upload button. To upload both in a single upload, zip both ...

So I have three devices for my ARRX15 remote, a TV, a Roku, and a generic OEM device used for a custom layout of the soft buttons. I did this because I want each device to have every possible button available when it's chosen directly, but I want a different load-out for actual usage.

The generic ...

Weird. I have several Xsight Colors and when I'm using them I probably charge the batteries maybe once a month - and I do NOT disable the motion sensor, and upstairs has wood floors, so they really are triggered by walking across the room. Using whatever I have on hand, usually Eneloops, Duracell ...

It's just the nature of the beast, I'm using the same remote with the same batteries. If you notice, if you walk by the coffee table the backlight comes on, so pretty much if you're in the same room with the remote, the batteries are draining. the motion switch is super sensitive and I'm not aware ...

Upload/download and backlight timeout have a huge impact on batteries. So change the timeout to the lowest setting and expect a lot of upload/downloads to drain the batteries. Also confirm that motion sensor is working properly and backlight isn't staying on longer than the setting.

Ah, didn't ...

I hope this is the right place to ask this, but I'm not sure where else to ask about this.

So I recently replaced a Nevo C2 with a ARRX15 because my Nevo fell and broke. I took the time to re-create the setup I had on the Nevo for the ARRX15 by exporting my devices to girr files and importing them ...

Ok, I'll make some more when I have time and upload them.
Well, I got three uploaded.

I made three icons for the C2, however they are device based.
With my TV, I have discrete input buttons, so I made icons label's which say the fallowing:
Chromecast Input, PS3 input, and RetroPie input.
I am not user where to upload them as they files section is limited to channels, local sub ...

Well don't I have egg on my face, it was right in front of me the whole time.
Thank you pH7_jp1.
And thank you again mdavej. Your help with the initial setup has been both incredible and extremely helpful. I am simply building off what you started, and you provided an excellent starting point!

I have a Nevo C2, and I would like to have the soft buttons be a mix of commands for a cable box and my TV. From what I have seen, I need to make a hybrid device in order to do this.
That's not a problem, except that I can't seem to get them to work.
I think the problem is that they use different ...