JP1 Remotes

For others with this Inteset 422-2: On this remote there are no hard labeled devices, instead there are A, B, C, and D. To activate the extender Press device A, then long press OK.

I have a Inteset 422-2 remote and a JP1 cable. I have installed the Common JP1.3 extender version 3.05 into a rmir file and uploaded it into the remote. The readme instructions say the following about activation:

The keymove to activate is on the TV/OK key (not visible to RMIR). To activate, press ...

Chances that this isn't MCE protocol like all other HP MCE receivers are very low. I think you'd get better results with that protocol rather than this bastardized RC5.

This is where my newbie status kicks in, I didn't know about the MCE protocol. The reason I went this route is because I have ...

Thanks for the help, I was able to transfer all the functions.

For anyone interisted, I have setup an upgrade for using Kodi and a MCE USB IR receiver. File is here: http://www.hifi-remote.com/forums/dload ... e_id=13861

Thanks for taking a look!

When you transfer the functions you are losing the device settings. On the functions tab, the device is defaulting to :
28,OBC<64
You need to change that to:
30,OBC<64
Just double-click in the device column on the functions page, and you will be able to select the desired ...

I have an Int-422-2, and I am trying to set it for use with my HTPC running Kodi. My IR receiver is an HP OVU400102/00 Media Center IR USB. I have two remotes that work out of the box with this receiver, the SageTV HD100 and the Hauppauge 45 key remote, both of which have upgrades available her on ...

I have an Inteset 422-2 and a JP1 cable. I have assigned my devices to the standard A, B, C, and D buttons. I have decided it would make my macros easier if I had assigned devices B, C, and D to Dev3, 7, and 8 instead. Is there an easy way to move the devices in RMIR or do I need to revert to my ...

unclemiltie wrote:I've been horribly busy with all kinds of other things to figure out where the pause isn't working. The rest of the extender seems to be OK as far as I can tell.

I just got a 422-2, is there anyway you can share the extender you are working on for that one?

TheShanMan wrote:That's a good idea, though I need to verify all the functions before I do that. The TV is a Vizio E70-C3.

I would be interested in that upgrade if you post it, I have a Vizio E55-C1 that I bet uses the same remote codes.