JP1 Remotes

I used many different kinds of button presses. I did long presses, short presses(of different speeds) and flutternig short presses. I just tried again for +4 hours with success on only a single number ( the "2" key ). It gave me some hope but I am at my wits end. I have been watching this thread in ...

Hi Robman,
I beleive that the pronto hex in the CCF file is somewhat dirty. I could not get very many of the buttons to work in my URC MX-810. I also could not receive help from the MX-810 people. My MX-810 and my MX-900 failed to learn the toggle bit from my oem CW remote. I have been up against a ...

If Protocol name in RM says "Manual", it's a much more difficult and involves decoding the signal and creating a new irp file.

I am eager to use make hex with the CW3000HD v.3 RM file. Can someone please advise me on how to create a new irp file for the CW3000HD. Do I use protocol builder with ...

there is a real good chance that the problem is mine alone

GurkhaBeast -
I tried to take a look at your ir.exe learned signal file and it would not open. "invalid command-line parameters"

I am not sure what this means(I am also new). I just thought you would like to know this may be a problem for Robman. Maybe some one else can confirm this with your file.

Ok Rob will do
Thanks for your help
Any word on the RM file?

joeyboey

Hi Rob,
I tested these codes in my MX-810 and colored red the ones that worked. Do these codes have something in common that is different from the rest? Can you think of anything else that I can do to get the rest working? Do you think your RM for the CW-3000HD be ready to use MAKEHEX any time soon ...

Thank you for your response!

The RM file I am trying to get HEX from is here
http://www.hifi-remote.com/forums/dload.php?action=file&file_id=5760

There is also a CCF of this device here if that helps
http://www.hifi-remote.com/forums/dload.php?action=file&file_id=5557

I am trying to get these ...

Is there a proper procedure to convert a RM file to clean hex code that can be used in mx editor?

Can someone please tell me which .irp file to use with this cw3000hd RM file. I would also like some instruction on how to decipher which bits to use when editing the irp file with bits from the RM file. I am trying to make clean hex from this RM file using KM and MAKEHEX. Am I going about this the ...